KKmulticopter V5.5 Controller BlackBoard V2.1 Program

Features:

- Simple structure, KKmulticopter is easy to Maintain and Debug Control
- With 3 pcs gyros, relying on potentiometer adjust gyro sensitivity.
- Full servo signal output, support normal ESC / analog servo
- Support for single-axis / UFO, Y3 3-axis, Y4-type 3-axis, 4 axis, 6 axis, V22  flight mode
- Supports 4-axis “+” and “X” flight mode, support for six-axis “HEXA6″ and “Y6″  flight mode.
- Don’t need MK 4-axis PPM decoder board, the receiver can be connected directly  to the Transmitter

Package included:　
- 1 x 4-axis Circuit Board

The KKmulticopter is a KK flight controller board for remote control multicopters with 2,3,4 and 6 rotors. We get KKmulticopter to stablise the aircraft during flight. KK flight controller takes the signal from the three gyros on the board (roll, pitch and yaw) and feeds the information into the Integrated Circuit (Atmega IC). KK flight controller then processes the information according the the KK software and sends out a control signal to the Electronic Speed Controllers (ESCs) which are plugged onto the board and also connected to the motors. Depending upon the signal from the IC the ESCs will either speed up or slow down the motors (and tilt the rear rotor with a servo in a Tricopter) in order to establish level flight.

The board of KKmulticopter also takes a control signal from the Remote Control Receiver (RX) and feeds this into the IC via the aileron, elevator, throttle and rudder pins on the board. After processing this information, the IC will then send out a signal to the motors (Via the M1 to M6 pins on the board) to speed up or slow down to achieve controlled flight (up, down, backwards, forwards, left, right, yaw) on the command from the RC Pilot sent via his Transmitter (TX). In the case of a Tricopter, one of the pin connectors (M4) will control a servo to achieve yaw authority.

The v.5.5 has an Atmega168 chip on board and an ISP header which gives users the option to tweak and upload their own controller code.

also we supply config, you can get KK flight controller at the link below,

Connection Digram

56k external modem

Specifications:
- 56k external modem
- Modem/Fax Data Rate 56Kbps Data Receive
- Modem/Fax Data Rate 48Kbps Data Send
- Modem/Fax Data Rate 14.4Kbps Fax
- Host Interface: USB 2.0
- Interfaces: 1 x RJ-11 Female Phone line, 1 x USB
- Package Contents: 1 x Modem, 1 x Driver CD, 1 x RJ-11 cable
Descriptions:
- 56k external modem
- Circuito integrato principale Conexant
- Tasso di trasferimento di 56Kbps 
- Automaticamente trasmetta e ricevi le caratteristiche del fax 
- Interfaccia del USB, plug and play.
- Interfaccia del telefono 2 RJ11
Features:
- 56k external modem
- Il tipo di modem di accesso telefonico comune 
- Tipi di external-tipi 
- Tipo di interfaccia USB 
- Tasso di trasferimento di 56Kbps 
- Protocollo V.90/V.92 K56flex di trasferimento 
- Fax/protocollo V.17, V.29, gruppo 3, codice categoria 1 
- Messaggio vocale a comando vocale, risposta automatizzata 
- Componendo le funzioni principali del Internet, automaticamente invii e ricevi il fax 
- Windows 98 /2000/xp/vista32/vista64/WIN 7/LINUX del sistema operativo
- Compatibilità: compatibile con A ed esteso all'insieme di ordine

vga to rca video converter

Features:
- Suitable for Laptop and Desktop
- Simultaneous display on VGA monitor and TV
- Support 640x480, 800x600, 1024x768 display mode
- Supports NTSC, PAL, PAL-M, PAL-N, AND SECAM video system
- Support position control & menu button Support over-scan & under-scan function
- Direct powered from USB Port
- No software driver requirement

Easy steps for connection:
- Connect the VGA input port of the BOX with the PC's VGA out-put port by a VGA cable
- Connect the Video or S-Video out-put port of the BOX with the TV's video or S-Video input
- Connect VGA out-put port of the BOX with the PC's monitor by a VGA cableDesciptions:

PC-to-TV converters,Connecting your TV to your PC is easy with VGA to RCA video converter. In other words you can plug one end of VGA to RCA video adapter into your computer and the other end into your television (works with your TV’s composite port, yellow RCA, or S-Video port).
Available Ports and Buttons

(1) DC 5V power input
(2) Dip Switch (to adjust NTSC/PAL. NTSC is default setting. No need to adjust if converter is used in North America)
(3) Composite out port (yellow RCA). This connects to your TV.
(4) S-Video out port. This can also connect to your TV.
(5) VGA out port. VGA to RCA video converter loop through, an optional port if you want to connect a VGA monitor in addition to your TV.
(6) VGA in port. VGA to RCA video converter signal comes from your computer (PC or Mac compatible).

(1)(2)(3)(4) Up, Down, Left, Right (respectively) adjust the picture position on your TV 
(7) Menu - On screen menu for further adjustments
(8) Zoom - press once to magnify, press twice to return
How VGA to RCA video adapter Works
Setting up VGA to RCA video adapter takes less than a minute with zero software or driver installations. Simply connect your computer’s VGA port to the VGA to RCA video adapter using the included VGA cable, and connect the yellow RCA composite port on the adapter to your TV with the included RCA cable (VGA to RCA video converter also comes with an S-Video cable if you prefer that port). VGA to RCA video converter sits near your PC and gets its power from your PC’s USB port through an included USB-to-5V-power tip cable. VGA to RCA video converter takes advantage of the power current coming from your PC so as not to require an additional power outlet. You can use your PC speakers, or you can get a 3.5mm to RCA audio cable to run sound to your TV.
Performance
You might be wondering why you need an active converter such as PC to TV converter box as opposed to a simple passive VGA to composite cable. The answer is that VGA and composite video are two completely different formats requiring the use of an active conversion. This means that the picture that comes out of the converter is going to be slightly different than the picture that came in. See this detailed article that includes screenshots and comparisons for this converter.
Watch a video on setting up the PC to TV converter.
Package Info:
Weight:375g  

Package included:
- 1x Universal PC VGA to TV Signal Converter Boxr
- 1x RCA video cable
- 1x USB Power Adapter Cable
- 1x VGA cable (1.5M)
- 1x S-Video cable
- 1x Manual(English)

4-Channel Digital Wireless Remote Control Wall Switch 50M

Control 4 light switch uses pairing coding, ultra high frequency encryption eliminates environmental interference. Remote control range is up to 50 meters, not obstructed by walls, capable of connecting any loads. Remote controller and switch can be used simultaneously for ease and flexibility.

Features:
- Control 4 light switch is fixed wall 4 channels light ON/ OFF switch with remote control
- Uses pairing coding; ultra high frequency encryption eliminates environmental interference
- Remote control range is up to 50 meters, not obstructed by walls
- Remote controller and switch can be used simultaneously for ease and flexibility
- Remote & manual operation
- Makes your life more convenient
- Fast, easy installation
- Just a remote controller, you can easily control the electrical appliances at home
- Remote control powered by one 23A/12V battery (included)
- Remote Range: 50M
- Power limit: <= 500W per Channel
- Standard 86-type outer casing
- Input: AC 200V-240V (50-60Hz)
- Receive Size: 85 x 85 x 35mm (L x W x H)
- Controller Size: 94 x 43 x 14mm (L x W x H)
- Color: White with Silver
- NOTE: For the indoor use only

Package included:
- 1 x 4-Channel Remote Control with Holder
- 1 x Receiver Switch Box
- 1 x 23A/12V Battery

Tags: control 4 light switch, control 4 light switchs, wireless wall switch

IR Night Vision CCTV MMS GSM Remote Camera RC Quad Band

Brand new gsm remote camera, 300K pixel camera pixel, 6 meter best shooting distance in night. The GSM remote camera is a remote images capturing device with a detect sensor, microphone, infrared lights and high quality camera.
You can also connect wireless sensors (433MHz or 315 MHz, Max.15 units), such as door magnet, pir sensor, smoke sensor, gas sensor etc. The remote security camera can report alarm from all sensors connected. Camera can send alarm both by SMS, MMS, email and by standard phone-call. The home security camera can send MMS images to any preset email. It will make your life safer and easier.
Features:
- Mobile Alarm: Capture images and Send to your mobile phone by MMS.
- SMS Remote Control: Control the camera by sending SMS commands.
- Real Time audio: Call the camera and listen in.
- Motion Detection: Detect any motion within the monitoring area and send alarm.
- External Connection: Connect wireless sensors (Max. 15), such as door magnet,pir sensor, smoke sensor, gas sensor etc. The camera can report alarm from all sensors connected.
- Infrared Light: The build-in IR light enables the camera to capture images in dark environment.
- Resolution: 300.00 pixel CMOS camera.
- Watch images directly on your mobile phone: The camera sends MMS images to your mobile phone for you to watch anywhere, anytime.
- Receive images by email: The camera can send MMS images to any preset email.
- Multi Alarm: Camera can send alarm both by SMS,MMS, email and by standard phone-call once motion is detected.
- Monitoring Methods: Choose between manually or scheduled monitoring.
- Remote Control: Include 2 remote controls for manual operation on/off and panic button.
- Bulit-in lithium battery: Rechargeable battery ensuring operation in case of external power failure
Specifications:

Power adapter	input 100V-240V/50Hz output DC 5V
Work temperature	-10-+45 degree
Store temperature	-10-+45 degree
Store temperature	-20-+60 degree
Relative humidity	10-90% without condensation
Work frequency	EGSM900, GSM1800 ,GSM850, PCS1900
Communication protocols (including data operation)	PHASE 2/2+
Receive code of Wireless sensor	ASK
Receive band of Wireless sensor	315 MHz or 433MHz
Effective range of the remote control	50 m
Max quantity of sensor	10 units
mage format	JPEG
Image resolution	QCIF(176×144), CIF(352×288), VGA(640×480)
Shooting angel	60 degree(horizontal), 60 degree (vertical)
Best shooting distance(nighttime)	>6 meters
Lithium ion battery	800mAh
Standby time of the battery (Depending on network)	24 hour

Package included:
- 1 x Camera Host
- 2 x Remote Control
- 1 x Power Adapter
- 1 x Wireless Sensor